[2017-Oct.-New]300-370 VCE 115Q Dumps Free Offered by Braindump2go[56-65]

Oct 10, 2017

2017 Oct. New 300-370 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 300-370 Questions:

1.|2017 New 300-370 Exam Dumps (PDF & VCE) 115Q&As Download:
https://www.braindump2go.com/300-370.html

2.|2017 New 300-370 Exam Questions & Answers Download:
https://drive.google.com/drive/folders/0B75b5xYLjSSNdGVBOXFERG9OSFU?usp=sharing

QUESTION 56
A network engineer has identified clients who are experiencing delays white roaming.
The network is configured with WPA2-Enterpnse. AES encryption, 802 1X authentication, and Cisco Centralized Key Management. Which change resolves the roaming delays?

A.    Utilize a supplicant that supports Cisco Centralized Key Management.”
B.    Enable AES and TKIP encryption
C.    Disable client session timeout
D.    Install wireless device drivers from Cisco

Answer: A

QUESTION 57
A recently acquired Cisco Aironet 1550 series AP is unable to join the WLC.
This message is observed on the AP console:
AAA Authentication Failure for UserName: CC93.1981.0035
User Type: WLAN USER
Which action must be taken for the AP to associate with the controller?

A.    Add MAC address CC93.1981.0035 to the Security AAA AP policy Authorization List.
B.    Authenticate the AP to the WLC from the console using an admin account on the WLC.
C.    Add MAC address CC93.1981.035 to the Security AAA MAC Filtering tab.
D.    Import the self-signed certificate of the AP to the Security:Certificate:LSC tab.
E.    Import the self-signed certificate of the AP to the Security:Certificate:SSC tab.

Answer: A

QUESTION 58
An engineer is using various techniques to discover and isolate rogues on the network.
For which technique must the engineer consider legal ramifications?

A.    rogue AP containment
B.    RF detection
C.    switch port tracing
D.    wire detection
E.    Cisco Prime Infrastructure location services

Answer: A

QUESTION 59
Refer to the exhibit. The AP is unable to join the controller. What is the cause of this error?

A.    The controller code version is lower than the code of the AP attempting to join.
B.    AP code is not the same as the controller and must download firmware.
C.    AP model \% not compatible with the controller code version.
D.    The AP is riot conjured in the controller auth-list of acceptable APs.

Answer: C

QUESTION 60
Refer to the exhibit. A VoWLAN has been deployed at a customer site. and users report that audio is choppy in some areas The exhibit captures a voice exchange between one phone that is associated to the AP at the end of the corridor (172.31 255 101) and another phone that is positioned in a conference room nearby.
Which action enhances the voice application quality of experience?

A.    Change the basic rate configuration on the WLC to include 54 Mbps.
B.    Change the WLAN QoS profile to platinum.
C.    Decrease the AP power level.
D.    Disable higher data rates on the controller.

Answer: A

QUESTION 61
A network engineer is having wireless multicast fail when it hits the wired network.
What command will show the source of multicast groups for troubleshooting?

A.    show ip igmp
B.    show ip mroute
C.    show ip mcache
D.    show ip interface counts
E.    show ip route

Answer: B

QUESTION 62
A customer wants FSR and certificate-based authentication. The solution must be simple to deploy. Which method should be used to meet the requirements?

A.    EAP-TLS
B.    PEAP-MSCHAPv2
C.    EAP-FAST
D.    PEAP-MSCHAPv2 machine authentication

Answer: C

QUESTION 63
A network engineer is upgrading the WLC image through the GUI for maintenance. What three transfer methods are available? (Choose three.)

A.    FTP
B.    SNMP
C.    TFTP
D.    SFTP
E.    HTTP
F.    SMB
G.    HTTPS
H.    SCP

Answer: ACD

QUESTION 64
During Layer 2 intercontroller roaming, which two items change? (Choose two.)

A.    SSID
B.    VLAN
C.    IP address
D.    AP
E.    controller

Answer: DE

QUESTION 65
Which set of commands assigns a standalone access point an IP address of 10.0.0.24 with a 27-bit subnet mask and a gateway of 10.0.0.1?

A.    config t
interface BVI1
ip address 10.0.0.24 255.255.255.192
exit
ip default-gateway 10.0.0.1
B.    config t
interface BVI1
ip address 10.0.0.24 255.255.255.224
exit
ip default-gateway 10.0.0.1
C.    config t
interface FastEthernet1
ip address 10.0.0.24 255.255.255.224
exit
ip default-gateway 10.0.0.1
D.    config t
interface Dot11Radio0
ip address 10.0.0.24 255.255.255.224
exit
ip default-gateway 10.0.0.1
E.    config t
interface FastEthernet1
ip address 10.0.0.24 255.255.255.192
exit
ip default-gateway 10.0.0.1
F.    config t
interface Dot11Radio0
ip address 10.0.0.24 255.255.255.192
exit
ip default-gateway 10.0.0.1