[March-2018-New]Exam Pass 100%!Braindump2go 352-001 PDF and VCE Dumps 510Q Instant Download[150-160]
2018 March New Cisco 352-001 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 352-001 Real Exam Questions:
1.|2018 Latest 352-001 Exam Dumps (PDF & VCE) 510Q&As Download:
https://www.braindump2go.com/352-001.html
2.|2018 Latest 352-001 Exam Questions & Answers Download:
https://drive.google.com/drive/folders/0B75b5xYLjSSNSUNBNi1aYkpfOTQ?usp=sharing
QUESTION 150
A service provider wants to maximize forwarding memory, routing memory, and CPU resources on PE devices for enterprise customers that have very few sites (two to three) and a large number of prefixes (several thousand).
Which service should the service provider offer these customers?
A. VPWS
B. VPLS
C. L3VPNs (RFC 2547-based)
D. InterAS L3VPN
Answer: A
QUESTION 151
FIFO queuing is being used on all routers in a network. The primary application running on the network is data backup using FTP. At certain times, users experience cyclical performance degradation.
What two things might mitigate this problem and help ensure bandwidth is used effectively in the network? (Choose two.)
A. traffic shaping
B. CB-WFQ
C. traffic policing
D. WRED
E. MDRR
Answer: BD
QUESTION 152
What are two reasons for instrumenting your network and network devices to collect performance data? (Choose two.)
A. to determine the impact of jitter and latency on application performance
B. to enable capacity planning decisions
C. to route traffic around constrained choke points in the network
D. to determine the locations at which QoS needs to be implemented
Answer: BD
QUESTION 153
Which three statements accurately describe OSPF route summarization? (Choose three.)
A. OSPF routes can be summarized at any OSPF router in the network using area range or summary
address commands.
B. OSPF internal routes can be summarized only at the ABRs.
C. OSPF type 5 external routes can be summarized only at the ASBRs.
D. Route summarization can lead to a more stable network.
E. OSPF internal routes are automatically summarized via type 3 summary LSAs.
F. A flat addressing scheme is required in order to summarize OSPF routes.
Answer: BCD
QUESTION 154
What are two reasons for instrumenting your network and network devices to collect performance data? (Choose two.)
A. to determine the impact of jitter and latency on application performance
B. to enable capacity planning decisions
C. to route traffic around constrained choke points in the network
D. to determine the locations at which QoS needs to be implemented
Answer: BD
QUESTION 155
Which tunneling mechanism provides confidentiality as well as tunneling capabilities?
A. MPLS L3VPN
B. IPsec ESP
C. L2TPv3
D. IPsec AH
Answer: B
QUESTION 156
You have designed a network to support two offices connected by a T1. Your router serial interfaces will be configured with encapsulation PPP. What will happen to your EIGRP neighbors if there is an LCP failure once your network is implemented?
A. Your neighbors will drop after the EIGRP timers expire.
B. Your neighbors will stay up because the link has not gone down.
C. Your neighbors will drop immediately.
D. Your neighbors will drop and EIGRP will begin the query process.
Answer: D
QUESTION 157
A junior engineer is implementing one of your optical designs and asks about CWDM (Coarse Wavelength Division Multiplexing). Which two features describe CWDM? (Choose two.)
A. typically used over long distances, but requires optical amplification
B. allows up to 32 optical carriers to be multiplexed onto a single fiber
C. shares the same transmission window as DWDM
D. uses the 850-nm band
E. Passive CWDM devices require no electrical power.
Answer: CE
QUESTION 158
Acme Corporation indicates that their network design must support the ability to scale to support a high number of remote sites. Which IGP is considered to scale better for a hub-and-spoke topology?
A. BGP
B. OSPF
C. IS-IS
D. EIGRP
Answer: D
QUESTION 159
You have been hired by a startup company to provide optical services using MPLS-TP. Which three options describe reasons to use the MPLS-TP standard in your design? (Choose three.)
A. MPLS-TP is a newer packet transport technology that replaces SONET/SDH.
B. MPLS-TP includes extensions to native MPLS OAM for fault detection, monitoring, and propagation.
C. MPLS-TP requires a routing protocol.
D. MPLS-TP uses an IANA assigned label 13 for OAM.
E. MPLS-TP uses Ethernet Y.1731 OAM.
Answer: ABD
QUESTION 160
Your company plans to implement an Internet gateway router that is performing NAT. This same gateway will be terminating various IPsec tunnels to other remote sites. Which address type is appropriate for the ACL that will govern the sources of traffic entering the tunnel in the inside interface?
A. inside local
B. inside global
C. outside local
D. outside global
Answer: B
!!!RECOMMEND!!!
1.|2018 Latest 352-001 Exam Dumps (PDF & VCE) 510Q&As Download:
https://www.braindump2go.com/352-001.html
2.|2018 Latest 352-001 Study Guide Video:
Post Author: mavis
